Cinemetrics | Guide
  • Welcome
  • Getting Started
    • Techincal Requirements
    • Downloading and Installing Cinemetrics
  • Your First Project
    • Understanding the Software UI
    • Creating a Project
    • Setting up the Testing Environment
    • Creating a Questionnaire
    • Analysis Environment: analysing individual users
  • Eye Tracking
    • Beam Eye Tracker: Prerequisites
    • Beam Eye Tracker: Setup and Calibration
  • GSR & PPG (Heart Rate)
    • Shimmer3 GSR+: Prerequisites
    • Shimmer3 GSR+: Connecting and Pairing with Windows
Powered by GitBook
On this page

Was this helpful?

  1. GSR & PPG (Heart Rate)

Shimmer3 GSR+: Connecting and Pairing with Windows

This section explains the process of pairing the Shimmer3 GSR+ Unit with a Windows PC.

PreviousShimmer3 GSR+: Prerequisites

Last updated 6 months ago

Was this helpful?

Step 1: Power On the Shimmer3 GSR+

  • Ensure the Shimmer3 is fully charged and operational. You can charge the Shimmer3 GSR+ using the built-in charging dock. Then, power on the device using the button located on the side.

The docking unit used for charging can also be used to update the firmware if needed by following the manufacturer’s instructions. Only update the firmware if absolutely needed.

Step 2: Enable Bluetooth on Your PC

  • Ensure Bluetooth is enabled on your Windows 10 or Windows 11 PC. You can check the Bluetooth Status by navigating to Settings > Bluetooth & Devices.

Step 3: Adjust Bluetooth Discovery Settings (Windows 11 only)

Windows 11 defaults to showing low-power Bluetooth devices only. You must turn on the advanced discovery option to allow Windows 11 to discover and connect to the Shimmer3 GSR+, which uses the standard Bluetooth protocol.

  • Navigate to Settings > Bluetooth & Devices > Devices, or click .

  • Scroll down, and change the "Bluetooth devices discovery" option from Default to Advanced.

Step 4: Pair the Shimmer3 GSR+ to Windows

Bluetooth devices must be paired to your computer to be fully operational. This procedure is often done one time per device. To pair the Shimmer device to Windows:

  • Navigate to Settings > Bluetooth & Devices and click on Add Device.

  • Select Bluetooth.

  • Wait for the Shimmer3 GSR+ to appear in the list of available devices, then select it.

  • When prompted, enter the pairing code. This code is printed on the back of the Shimmer3 GSR+ Unit. Note: This code is unique and fixed for each device.

Once pairing is complete, the Shimmer3 GSR+ should appear under Paired Devices in your Bluetooth settings. Cinemetrics can now establish a connection with the Shimmer. To learn how to connect Cinemetrics to the Shimmer, follow the guide from the section .

Setting up the testing environment
here to open Windows Settings